Teledyne Lecroy WaveJet Touch, Руководство по началу работы

Страница: 13 / 40

9
WaveJet Touch Getting Started Guide
SET UP
Carrying
The oscilloscope’s case contains a built-in carrying handle . Always
unplug the instrument from the power source before lifting and carrying it.
Powering On/Off
Connect the line cord rated for your country to the AC power inlet on the
back of the instrument, then plug it into a grounded AC power outlet. (See
Power and Ground Connections in “General Safety Information.”)
The
Power button controls the operational state of the oscilloscope.
Press the button to switch on the instrument; press it again to switch “off”
(Standby power).
CAUTION. Do not power on or calibrate the oscilloscope with a
signal attached.
The Power button does not disconnect the oscilloscope from the AC
power supply; some “housekeeping” circuitry continues to draw power.
The only way to fully power down the instrument is unplug the AC line
cord from the outlet.
CAUTION . Do not place the instrument so that it is difficult to
reach the power cord in case you need to disconnect from power.
We recommend unplugging the instrument if it will remain unused for
a long period of time and at least once every six months to inspect and
clean the plug.
Connecting
After start up, configure connections from the oscilloscope using the
Utilities menu options listed below. See the WaveJet Touch Oscilloscopes
Operator’s Manual for more detailed instructions.
External Controller
The WaveJet Touch supports remote control via GPIB, USBTMC, or TCP/IP
(LAN) connection.
Connect a cable from the appropriate port
on the back of the instrument
to the controller. Press the front panel Utilities button and from the
touchscreen choose Next > Remote . Turn the Interface On and select the
connection type.
Other Auxiliary Device
The Aux Out connector can be configured to send a pulse to another device
when a trigger event occurs or using pass/fail criteria.
Connect a BNC cable from Aux Out on the back of the instrument to
the other device. Press the front panel Utilities button and from the
touchscreen choose Next > AUX OUT . Select the signal type.
Printer
WaveJet Touch supports PictBridge-compliant printers. Connect the printer
to the host USB port on the front of the instrument. Press the Utilities
button and from the touchscreen choose Print > Device . Select Printer.