Teledyne Lecroy WaveJet Touch, Руководство по началу работы

Страница: 17 / 40

USER INTERFACE
13
WaveJet Touch Getting Started Guide
Descriptor Box
The Acquisition status bar appears above the grid. It shows information
related to timebase, trigger mode (which determines if the acquisition is
running or stopped), and sweeps count.
The
grid area displays the waveform traces. Each trace is color-coded
to the channel and marked with the channel number. You can adjust the
brightness (intensity) of the display to make trace lines more visible.
Cursor lines show where measurement points have been set. These
white, dotted lines appear bold when they are selected. Turn the Adjust
knob to reposition an active cursor.
Trigger level (vertical axis) and trigger position (horizontal axis) indicators
appear on the grid when a trigger is set, color-coded to match the input.
Other
measurement readouts appear in a table below the grid when
measurements have been applied to a trace.
The
Trigger status bar appears immediately below the grid (or readout
table if measurements are on) and shows the current trigger setup. It also
shows cursor readouts when time cursors are applied.
Channel (1-4), and Math (M)
descriptor boxes appear below the Trigger
status bar and summarize current setups for each trace, as well as cursor
readouts when amplitude cursors are applied. They are color-coded to
the trace when the trace is on. Touch the descriptor box to open the
corresponding set up menu.
A
Message bar appears along the bottom of the screen. Any error or
processing messages appear here, along with input and acquisition
memory information and the timestamp.
Channel Number
Gain Setting
Pre-Processing Summary
Coupling
Trace Off
Level Position
Trigger Indicators
Intensity 20%
Display Intensity
Intensity 80%
Offset
Trace On