TCM260904
Rev
0.1
TCM260904
Page 13 of 31
E.U.
STANDARD
P
OWER
-O
N
M
ODE
(1)
Rotate “EMS” mushroom clockwise 45º and pull out.
(4)
Turn Key switch clockwise to “ON” position.
(2)
Turn Key switch 45º beyond “ON” position to turn on power.
(3)
After 3 minutes of non-operation, transmitter will send out an emergency stop signal to the receiver. When
this occurs, one must turn the magnetic key counter-clockwise to the “OFF” position, then turn the key
clockwise to the “ON” position, and press “Start” pushbutton to turn on the power.
Note
:
When setting is on “E.U. standard” Power-on Mode, the transmitter is in the continuous mode.
S
OFTWARE
P
OWER
-O
N
M
ODE
This “Power-On” mode is controlled by the software. It consists of:
(1)
Whether the receiver Power-Off automatically when no operation for a period of time.
(2)
Whether a password is required to turn on power.
(3)
Whether an “emergency stop” signal will be sent out…
etc.
A
CCELERATION
/
D
ECELERATION
O
PERATION
(1)
“South” pushbutton is the acceleration pushbutton; “North” pushbutton is the deceleration pushbutton.
(2)
When a motion is in the second speed, quick touch of acceleration pushbutton will double the speed.
Repeated touch of acceleration pushbutton will increase the speed up to 5 times.
(3)
To reduce the speed, touch the deceleration pushbutton. Repeated touch of deceleration pushbutton will
reduce to the second speed.
Note:
(1)
When accelerate/decelerate, the motion pushbutton must be depressed and held in the second speed. If
motion pushbutton is released, there will be no acceleration/deceleration and speed will return to zero.
(2)
Press “North” pushbutton will perform the “Alarm” function if the speed is reduced to the second speed.
I
NCHING
O
PERATION
(1)
“South” pushbutton is set for “inching” pushbutton.
(2)
Press and hold inching pushbutton.
(3)
Press any motion pushbutton to perform the inching motion.
Note: The other pushbutton of transmitter must be released before press inching pushbutton.