Tektronix TDS6404, Руководство по обслуживанию

Страница: 72 / 252

Brief Procedures
4- 16
TDS6000 Series Service Manual
c. In the Save Instrument Setups As dialog box, select the 3
1
/
2
Floppy (A:)
icon in the Save in: drop-down list to set the save destination to the
floppy disk.
d. Note the default file name, and then click the Save button to save the
setup to the default file name.
9. Change the settings again: Set the horizontal SCALE to 200 s/div .
10. Verify the file system works:
a. Click the Recall Setups tab in the control window.
b. Click the Recall button under Recall settings from file in the control
window. This displays a familiar Windows dialog box for locating the
settings file that you want to recall.
c. In the Recall Save Instrument Setups From dialog box, select the
3
1
/
2
Floppy (A:) icon in the Look in: drop-down list.
d. Locate and then double click in the dialog box on the setup file that you
previously stored.
e. Verify that the oscilloscope retrieved the saved setup from the disk. Do
this by noticing that the horizontal SCALE is again 1 ms and the
waveform shows ten cycles just as it did when you saved the setup.
11. Remove the test hookup:
a. Disconnect the BNC cable and adapter from the channel input and the
probe compensation output.
b. Remove the floppy disk from the floppy disk drive.