Tektronix TDS6404, Руководство по обслуживанию

Страница: 71 / 252

Brief Procedures
TDS6000 Series Service Manual
4- 15
Equipment
required One BNC cable, such as Tektronix part number 012-0076-00
One TCA-BNC adapter
One 1.44 Mbyte, 3.5 inch DOS-compatible formatted disk.
Prerequisites None
1. Initialize the oscilloscope: Push the front-panel DEFAULT SETUP button.
2. Hook up the signal source: Connect the BNC cable from the probe com-
pensation output to the CH 1 input through a TCA-BNC adapter as shown in
Figure 4--7.
TDS6000 Series
BNC cable from PROBE
COMPENSATION output to
CH 1 input
Figure 4- 7: Setup for the file system test
3.
Insert the test disk: Insert the floppy disk in the floppy disk drive at the top
of the front panel.
4.
Set up the oscilloscope:
Push the front panel AUTOSET button.
5. Pull down the Vert menu, select Vertical Setup, and then touch Offset .
Adjust the Ch1 Offset to approximately 0.8 V using the multipurpose knob.
6. Set the Vertical SCALE to 100 mV per division.
7. Set the time base: Set the horizontal SCALE to 1 ms/div . The time-base
readout is displayed at the bottom of the graticule.
8. Save the settings:
a. Pull down the File menu to select Instrument Setup . . . . This displays
the instrument setups control window.
b. Click the Save button under Save settings to file in the control window.
This displays a familiar Windows dialog box for choosing a destination
directory naming the file.
Verify the File System