Tektronix RFA300A, Руководство пользователя

Страница: 95 / 112

Appendix C: System Recovery
RFA300A Measurement Set 8VSB
C- 5
If Partitions 1 and 2 are both corrupted or you want to restore the hard drive to
factory status, use the
Partition 1 procedure on page C--4, except replace
restp1.bat with restdisk.bat. This will remove all of the data from both partitions.
To restore only Partition 2 to factory status, removing all data from Partition 2
without removing data from Partition 1, you can use the following procedure.
This procedure uses the Windows NT Disk Administrator tool to create a new
Parition 2. After you create Partition 2 using this procedure, if you later use the
Easy Restore Partition 1 procedure on page C--4, Partition 2 will be preserved
in most cases.
NOTE
. You typically do not need to use this procedure; the Easy Restore
procedures are normally sufficient to restore Partitions 1 and 2.
To create Partition 2, perform the following steps:
1.
From the Start menu, select
Program
,
Administrative Tools
, and then
Disk
Administrator .
2. Click CD-ROM .
3.
From the Tools menu, select
Assign Drive Letter
.
4. Select E: for the CD-ROM.
5.
Click the unpartitioned space on disk 1.
CAUTION.
It is important to select Create Extended in the following step.
6. From the Partition menu, select Create Extended to create an extended
partition. Use all of the remaining free space.
7. From the Partition menu, select Commit Change Now .
8. Click within the partition that you just created.
9. From the Partition menu, select Create to create a logical drive. Use all of
the free space. Assign drive letter
D:
if needed.
10. From the Partition menu, select Commit Change Now .
11.
From the Tools menu, select
Format the new partition
. Format it with the
NTFS file system
.
Easy Restore
Partitions 1 & 2
Create Partition 2