Tektronix NetTek YBT1E1, Руководство пользователя

Страница: 103 / 122

Appendix B: Installing NetTek YBT1E1 Software
NetTek YBT1E1 T1 & E1 Circuit Tester User Manual
B- 3
Installing Using an RS-232 Serial Connection
1. Connect one end of an RS-232 cable to the serial (COM) port on
the desktop PC.
2.
Connect the other end of the cable to the NetTek Analyzer
Platform serial port.
If the desktop PC serial interface has already been configured to use
Windows CE Services or Active Sync, you must disable the serial
connection as explained below.
Disabling the Windows CE Services Serial Connection
If Windows CE Services is installed, you must do the following to
disable the serial connection:
1. Right-click on the Windows CE Services icon in the desktop PC
status area; then select
Communications .
2. In the Windows CE Services Properties dialog box, open the
Communications tab.
3. In the Device Connections via Serial Port field, deselect
Enabled
. (Enable mobile device connection must already be
selected to make this selection).
4. Select OK ; then close the dialog box.
Disabling the Windows Active Sync Serial Connection
If Windows Active Sync is installed, you must do the following to
disable the serial connection:
1. Right-click on the Active Sync icon in the desktop PC status area;
then select
Connection Settings .
2. In the Connection Settings dialog box, deselect the Allow serial
cable or infrared connection to this COM port check box.
3. Select OK to close the dialog box.