Tektronix 070-8462-03, Инструкция по эксплуатации

Страница: 46 / 271

Operating Basics
1735 HD High Definition Waveform Monitor
2–9
Use the UP / DOWN buttons to position the cursor next to CALIBRATOR, then
push MENU. Use the DOWN button to select the Calibrator signal (or return to
main menu). If you have selected the calibrator, press MENU once and the
calibrator will appear on the screen. It should consist of two horizontal traces,
approximately 700 mV apart. Use the front-panel VERTICAL screwdriver
adjustment to set the calibrator to exactly 700 mV, then press any front-panel
control to exit the Calibrator and return to normal front-panel controlled
operation.
Rear-Panel Connectors
Refer to Figure 2–3 for rear-panel connector locations.
1. INPUTS
These six high-impedance loop-through video inputs (Channels 1A, 2A, 3A,
1B, 2B, and 3B) correspond to front-panel push-button selections. These
inputs are compensated for 75
W
, but are not internally terminated.
2. EXT REF
This high-impedance loop-through video input is compensated for 75
W
but
not internally terminated. This input is AC coupled.
3. PIX MON
The PIX MON 75
W
output signal corresponds to the front-panel-selected
display. This signal has a brightup pulse in the LINE SELECT mode, and is
used to drive a picture monitor.
4. REMOTE
The REMOTE 15-pin D-type connector provides the following remote
control functions and inputs:
a. Turn input channels On / Off.
b. Select sweep rates.
c. Remote Sync input and enable.
d. 10V RGB staircase input and enable.
e. External Horizontal input and enable.
f. Store and Recall.
Calibration
Loop-Through Inputs
Multi-Pin Connectors