Tektronix 070-8462-03, Инструкция по эксплуатации

Страница: 116 / 271

Performance Verification
1735 HD High Definition Waveform Monitor
5–5
NOTE . When selecting an input channel, CH1, CH2, or CH3 must be selected as
well as A or B. (For example, push the CH1 and A buttons for a display of
CH1A.)
When selecting a sweep rate, the ONE/TWO/ THREE and LINE/FIELD buttons
must both be pushed. (For example, push ONE and LINE for a one-line display.)
1. Preliminary Setup
a. Connect the 1735 HD AC power cord to the variable autotransformer as
shown in Figure 5–2. Turn power on and set the autotransformer for the
voltage shown by the rear-panel line voltage indication.
b. Set the 1735 HD front panel as shown in Table 5–2.
Figure 5–2: Initial equipment hookup for Performance Checks
Table 5–2: 1735 HD initial control settings
Control Setting
POWER ON
INPUT CH 1A
CLAMP off
REF CH 1
VAR Off
FILTER FLAT
ONE – TWO – THREE ONE
LINE – FIELD LINE
MAG – READOUT Off
LINE SELECT Off
FOCUS as desired
Standard Performance
Check Procedure