7. WINDOWS NT DRIVERS
DC-390 Series User’s Manual
51
51
4.
Press "
S
" to skip mass storage device detection. The next screen will show: “Setup has
recognized the following SCSI Adapters in your computer: (none).” Choose to configure
an additional SCSI adapter by pressing "
S
", and continue with the following steps:
5.
On the next screen, NT will show various drivers. Choose: "
Other (Required disk
provided by a hardware manufacturer)
" and press ENTER.
6.
NT will prompt for the "Manufacturer-supplied support disk". Insert the DC-390 driver
diskette in drive "A" and press ENTER.
7.
NT will check the floppy and show:
"Tekram DC-390 NT 3.51 & 4.x PCI SCSI Driver Ver. XXX"
"Tekram DC-390 NT 3.1 & 3.5 PCI SCSI Driver Ver. XXX"
Select the NT version you want to install and press "ENTER".
8.
After NT scans the hardware and finds the controller, it will display:
“Setup has recognized the following SCSI Adapters in your computer:"
"Tekram DC-390 PCI SCSI Adapter Ver. XXX"
Press ENTER to continue and copy the driver files.
Boot from CD-ROM : (DC-390/U2B/U2W)
You can boot from CD-ROM when you set the CD-ROM as a boot device from Main Board
BIOS for ATAPI CD-ROM or DC-390/U2B/U2W boot up screen for SCSI CD-ROM .
1.
Press "
F6
" key when the screen shows" Setup is inspecting your Computer's hardware
Configuration".
2.
The next screen will show: "Setup could not determine the type of one or more mass
storage device installed in your system ...". Choose to configure an specify additional
SCSI adapter by pressing "
S
".
3.
On the next screen, NT will show various drivers. Choose: "
Other (Required disk
provided by a hardware manufacturer)
" and press "
ENTER
".
4.
NT will prompt for the "Manufacturer-supplied hardware support disk" into drive A:
Insert the DC-390 serier driver diskette in drive "
A
" and press "
ENTER
".
5.
NT will check the floppy and show:
"Tekram DC-390 NT 3.51 & 4.x PCI SCSI Driver Ver. XXX"
"Tekram DC-390 NT 3.1 & 3.5 PCI SCSI Driver Ver. XXX"
Select the NT version you want to install and press "
ENTER
".
6.
After NT scans the hardware and finds the controller, it will display:
"Setup has recognized the following Mass Storage devices in your computer:"
"Tekram DC-390 PCI SCSI Adapter Ver. XXX"
