Teka JZC 63312 A, Руководство пользователя

Страница: 55 / 160

55
Fulfillment with Energy Efficiency of the
appliance:
- Appliance has been tested according to
standard EN 60350-2 and the obtained value, in
Wh/Kg (see the relative table).
Following advices will help you to save energy
anytime you cook:
● Use the correct lid for each pot whenever is
possible. Cooking without lid uses more energy.
● Use pans with flat bases and appropriate base
diameters in order to match size of the cooking
zone. Pan manufacturers usually provide top
diameter of the pot that is always larger than
bases diameter.
● When water is used for cooking, use little
quantities in order to preserve vitamins and
minerals of vegetables and set the minimum
power level that allows maintaining the cooking.
High power level is unnecessary and a waste of
energy.
● Use small pots with small quantities of food.
IF SOMETHING DOES NOT WORK
Before calling the technical service, perform the
verifications described below.
The appliance does not work:
ensure that the power cable is plugged in.
The induction zones do not produce heat:
the container is not appropriate (it does not have a
ferromagnetic bottom or is too small).
Check that the bottom of the container attracts a
magnet, or use a larger container.
A humming is heard when starting to cook in
the induction zones:
with containers which are not very thick or not of
one piece, the humming results from the
transmission of energy directly to the bottom of the
container.
the humming is not a defect, but if you wish to
avoid it anyway, reduce the power level slightly or
use a container with a thicker bottom, and/or of
one piece.
The touch control does not light up or, despite
lighting, does not respond:
no heating zone has been selected.
Be sure to select a heating zone before operating
it. There is humidity on the sensors, and/or your
fingers are wet. Keep the touch control surface
and/or your fingers clean and dry. The locking
function is activated. Unlock the controls.
The sound of a fan is heard while cooking,
which continues even after cooking has
ended:
the induction zones have a fan to keep the
electronics cool. This only operates when the
electronic circuits get hot. It stops again when the
circuits cool whether the hob is turned on or not.
The symbol will appear on the power
indicator of a hotplate:
the induction system does not find a pot or pan on
a hotplate or it is of an unsuited type.
The hotplate will switch off and the messages
C81 or C82 appears on the indicators:
excessive temperature in the electronics or on the
glass. Wait for a while for the electronics to cool
down or remove the pot or pan so that the glass
can cool.
The appliances switches off and the message
C90 appears on the power indicators (3):
the touch control detects on/off (1) sensor is
covered and doesn’t allow switching on the
cooktop. Remove the possible objects or liquids
keeping the touch control surface, clean and dry
until the message disappears.
USE