Teka JZC 63312 A, Руководство пользователя

Страница: 59 / 160

59
Timer Function
(countdown clock)
This function facilitates cooking given that you
don’t have to be present: you can set a timer for a
plate, and it will turn off once the derired time is
up.
For these models, you can simultaneously
program each plate for durations ranging from 1 to
99 minutes.
Setting a timer on a plate.
Once the power level is set on the desired zone,
and while the decimal dot of the zone keeps on,
the zone will be able to be timed.
To that end:
1
Touch sensor (10) or (11). Timer
indicator (12) will show “
00
” and corresponding
zone indicator (3) will show the symbol
blinking alternately with its current power
level.
2
Immediately afterwards set a cooking time
between
1
and
99
minutes, using the sensors
(10) o (11). With the first one the value
will start at
6
0, whereas with the second it will
start at
01
. By keeping sensors (10) or
(11) pressed, the value will be restored to
00
.
When there is less than one minute left, the clock
will begin to count down in seconds.
3
When the time indicator (12) stops flashing, it will
start to count down the time automatically. The
indicator (3) relating to the timed hotplate will
alternately display the selected power level and
the symbol
.
Once the selected cooking time has elapsed, the
heating zone being timed is turned off and the
clock emits a series of beeps for several seconds.
To turn off the audible signal, touch any sensor.
The timer indicator (12) will display a flashing
00
beside of the decimal dot (4) of the selected zone.
If the heating zone turned off is hot, its power
indicator (3) will display alternately the
H symbol
and a “-”.
If you wish to time another hotplate at the same
time, repeat steps 1 to 3.
If one or more zones are already timed, the timer
indicator (12) will show by default the shortest
remaining time to finish, showing a “
t
” on the
related zone. Rest of timed zones will show on
their corresponding indicator zones the decimal
dot blinking. When cursor “slider” of another timed
zone is pressed, the timer will show the remaining
time of that zone for a few seconds and its
indicator will show its power level and the “
t
”
alternately.
Changing the programmed time.
For modifying programmed time, cursor “slider” (2)
of timed zone has to be pressed. Then it will be
possible to read and modify the time.
Through sensors (10) and (11), you can
modify the programmed time.
Disconnecting the clock
If you wish to stop the clock before the
programmed time is up, this can be done at any
time by simply adjusting its value to “--”.
1 Select the desired plate.
2 Adjust the value of the clock to “ 00 ” by using the
sensor (10). The clock is cancelled. This can
also be done more quickly by pushing the
sensors
(10) and (11) at the same
time.
USE