Teeter FitSpine LX Inversion Table, Руководство по сборке, Страница: 7 / 44

Unpack and Prepare Your Workspace
• If possible, assemble the equipment at or near the space in which you intend to use it to avoid moving it later.
• Unpack all parts and support materials. Set aside packing materials and clear your work area.
• Locate the Hardware Kits packaged with the manuals. They are labeled to correspond with the assembly process.
L E T ’ S G E T STA RT E D
5
FIGURE 4
FOR ALL MODELS:
A S S E M B L E B OA R D I N G PL AT FO R M
S T E P 1
Figure 1
IMPORTANT:
Do not fully tighten the bolts
until all the bolts have been screwed in and
the platform is properly aligned.
Remove the A-frame from the box and place
it on its back side so that the open ends of
the A-Frame are pointing up.
Locate the Boarding Platform and the
Boarding Platform Hardware Kit, including (2)
Rubber Feet and (4) Boarding Platform Bolts.
Insert both open ends of the Boarding
Platform into the open ends of the A-Frame.
INSIDE
OUTSIDE
Figure 1
Figure 2
Figure 2
NOTE:
Each side of the Boarding Platform is
secured to the A-frame through two holes,
‘inside’ and ‘outside’. The ‘inside’ holes are
also used to secure the Boarding Platform
Rubber Feet.
Facing the underside of the Boarding Platform,
position a Rubber Foot over one inside hole
and hand-tighten with a Boarding Platform
Bolt. Repeat on the other side.
Hand-tighten a Boarding Platform Bolt into
one outside hole. Repeat on the other side.