Teeter FitSpine LX Inversion Table, Руководство по сборке, Страница: 13 / 44

FIGURE 4 FIGURE 4
S T E P 4
A S S E M B L E TA B L E B E D TO A- F R A M E
Failure of the Self-Locking Hooks to close over both Roller Hinge
Pivot Pins is an indication of improper assembly and if not cor-
rected could result in serious injury or death!
WARNING
!
Figure 18:
Rotate the Table Bed so that it is facing
up. Ensure that it rotates smoothly. See also Image
A on Page 13 to ensure misassembly has not
occurred.
TOP VIEW
INSIDE VIEW
Figure 16:
Lower each Roller Hinge Pivot Pin into the
A-Frame hinge plates, one side at a time. The Self-
Locking Hooks will open to allow the Pivot Pin into
the Hinge Plate slot, then automatically snap closed
over the Pivot Pin.
TIP:
You may need to push outward on the Hinge
Plate in order for the second Pivot Pin to lock in
place.
Figure 17a & 17b:
Make sure that each Pivot Pin is
seated at the base of the slot in the Hinge Plates, and
that the Self-Locking Hooks have closed over both
Pivot Pins.
Figure 15:
Face the front of the A-Frame where the
Crossbar is located. Grasp both Roller Hinges, right
above the Cam Lock, and lift the Table Bed. Allow
the top of the Table Bed to rotate toward the floor, so
that the back of the Table Bed is now facing you and
the top of the Table Bed is in front of the Crossbar.
Figure 15
Figure 16
Figure 18
Figure 17b
Figure 17a
The LX4 is shown here. Your actual model may vary.
11