Teeter FitSpine LX Inversion Table, Руководство по сборке, Страница: 14 / 44

FIGURE 4 FIGURE 4
S T E P 5
ASSEMBLE MAIN SHAFT TO TABLE BED
Figure 19
Figure 20
REVISIONS
ENGR DATE REV SHT ZONE DESCRIPTION
NMS 10/18/2017 A 1 8D A1: RELEASE FOR PATENT
PARTS LIST
ITEM QTY NET DIMENSIONS/DESCRIPTION NOTE MATERIAL SHT
REVISION STATUS
SHT 1
REV A
8
A
1 2 3 4 5 6 7
D
C
B
C
A
D
B
5 3 1 6 2 4 8 7
8
A
1 2 3 4 5 6 7
D
C
B
C
A
D
B
5 3 1 6 2 4 8 7
figure 18
SHEET 1 OF 1
REV
PROJECT:
DRAWN
UNLESS OTHERWISE NOTED
SURFACE ROUGHNESS PER ANSI B46.1
DIMENSIONING PER ASME Y14.5-2009
WELD SYMBOLS PER AWS A2.4
FINISH:
UOS 63RMS ON
MACHINED
SURFACES OR
AS PROCURED
.X
.XX
.XXX
ANGLE
EXPECTATIONS PROPRIETARY
THE INFORMATION CONTAINED HEREIN
IS PROPRIETARY TO EXPECTATIONS AND
SHALL NOT BE REPRODUCED IN WHOLE
OR IN PART OR USED FOR ANY PURPOSE
EXCEPT WHEN SUCH USER POSSESSES
DIRECT WRITTEN AUTHORIZATION
FROM EXPECTATIONS LLC
SCALE: FULL SIZE:
D
A
TOLERANCES
UNLESS NOTED
= .1
= .03
= .005
= 1
NICK SOLLER
FILLET RADII: .005-.010
CORNER BREAK: .005-.010
ALL DIMENSIONS IN INCHES
EXPECTATIONS LLC
PUYALLUP, WA 98391
DRAWING
PROJECT NAME HERE
Figure 19a
Figure 21
The LX4 is shown here. Your actual model may vary.
12
Figure 21:
Test the inversion table by hand for
smooth and steady rotation and ensure that
all fasteners are secure.
Figure 19:
Stand on the LEFT side of the
A-Frame, holding the Main Shaft with the
height markings facing up. Begin to slide
the end of the Main Shaft into the Main Shaft
Housing at the base of the Table Bed.
Figure 19a:
With your right hand, pull out the
Height-Selector Locking Pin and slide the
Main Shaft in further. Release in the desired
height setting. Refer to the User Guide for
more information on selecting your height
setting.
Figure 20:
The Main Shaft MUST REST against
the Crossbar of the A-Frame.
IMPORTANT:
The Crossbar prevents the Table
Bed from rotating forward when the user
steps on the Ankle Comfort Dial. If the Main
Shaft does not rest on the Crossbar as shown
here, then the Table Bed has been assembled
backwards onto the A-Frame. This must be
corrected before use.