Betriebsanleitung/Operating manual
E3905 / P3394
BD_BE 763 b
35
6 Operation of logger
The device supports two different logger functions:
„Func-Stor“: each time when the key: “store / Quit” is pressed
a measurement will be recorded.
„Func-CYCL“: measurements will automatically be recorded each interval. Which was set in the
logger menu, “CYCL” until the logger will be stopped or the logger memory is full.
The recording is started by pressing key: “Store / Quit” for 2 seconds.
For the evaluation of the „Func-CYCL“-data the tecsis software GSoft has to be used. The
software also allows easy configuration and starting of the logger.
Please note: When the logger is activated (Func Stor or Func CYCL) the hold function is no more
available, the key: ´store/Quit´ is solely used for the operation
of the logger functions.
6.1
„Func-Stor“: Storing single measurements
Each time when key:´store/Quit´ is pressed a measurement and its time stamp will be recorded.
The recorded data can be viewed either in the display (when calling the configuration an additional
menu „REAd LoGG“ is displayed, see below) or by means of the interface and a PC with GSoft-
software.
Max. number of measurings: 99
A measuring max. contains:
-
Sensor 1 current value at point of storage
-
Sensor 1 Min.-Peak, Max-Peak since last storage
-
Sensor 2 current value at point of storage
-
Sensor 2 Min.-Peak, Max-Peak since last storage
-
Current difference of Sensor 1 – Sensor 2 at point of storage
-
Min.-Peak, Max-Peak of difference of Sensor 1 – Sensor 2,
-
Min.-Peak, Max-Peak since last storage
-
Time and date of storage
After each recording „St. XX“ will be displayed for a short time. XX represents the number of the
recording.
