Secure the hoses using the provided metallic clamps then double check the tightening.
Keep the hoses close to the lane sides.
Using the provided bracket, install the booster pump as shown in the picture and connect the hose
TF12 between pump and manifold PR.
Secure the hose using the provided metallic clamps then double check the tightening.
Install the four slides on left and right lanes as shown
Fit the floating sensor to the booster pump.
Adjust the level sensor till obtain a change of status when the water level reach the base of the
electric motor (yellow arrow in the above picture).
Pay particular attention to this regulation as the correct execution of this step is crucial for the life of
the booster pump.
ATTENTION
An incorrect regulation of the level sensor may damage the pump irremediably
Using the provided brackets and bolts, install the side walls on the dedicated supports as shown in
Tecnoter srl unipersonale
Wheel washing
system
RC4.32
E16CL4
S/N
Page 23/39
Rev: 1.42 –
22/02/2017
Slide
Booster pump
Floating
sensor