Tecno-gaz Master-Flux, Инструкция по эксплуатации, Страница: 52 / 116

ENGLISH
22
RESUSCITATION WITH MASTER FLUX
KIT Art. 1504/A (Not included) (FIGURE A11)
RESUSCITATION procedures WITH MASTER FLUX must be carried out with
the
%N2O knob (C – figure A10) that regulates the percentage of nitrous oxide in
position 0%.
SLOWLY open the oxygen cylinder valve (turn the valve counter-clockwise); make
sure that the nitrous oxide cylinder is closed (turn the valve clockwise).
Take the Master Flux mask kit off by sliding it off of the spiral tube.
Insert the relative fitting (25) into the spiral tube.
Connect the end of the oxygen treatment tube (24) to the fitting (25) .
Connect the other end of the oxygen treatment tube to the bottom stud of the resuscitation
bag
(23) through the relative coupling.
Connect the mask (22) , to the valve on the resuscitation bag.
Turn the FLOW knob (A - figure A10 ) to deliver Oxygen at the required flow rate, check the
flows displayed on the flow columns (E, D - figure A10) .
The nitrous oxide column E=0
The oxygen column D=set flow
Place the mask on the patient.
Act on the resuscitation bag in accordance with the resuscitation instructions.
Once use of the device is finished it is IMPORTANT to close the valve on the Oxygen
cylinder (by turning it clockwise).
22
23
24
25
Figure A11