Tecmar Technologies 51000HT, Инструкция по установке и эксплуатации

Страница: 20 / 46

8 SQICUGM-EN2 Rev. A
Preparing the QIC Drive
1. Touch the power supply to discharge any static electricity on your body.
Caution: Handle the drive with care; do not expose the
unit to excessive shock.
2. Remove the drive from its anti-static bag.
3. The QIC drive is shipped with a 5-1/4-inch bezel (plastic front plate and
drive door). If a different bezel is required for installation on your computer,
refer to Appendix B for bezel removal and replacement instructions.
Setting the SCSI ID and SCSI Bus Termination
The QIC drive has been shipped with the standard default configurations shown
in Table 1. In most cases, these settings result in a successful installation. If the
drive does not operate properly after installation, or if you wish to change these
settings, refer to Appendix A for additional information.
4. If side rails are required to
mount the drive in your
computer, mount the supplied
side rails on the drive.
NOTE: Exact placement of the
rails will depend on your
computer housing. If the supplied
rails cannot be adapted to your
computer, contact your computer
dealer for the correct rails for
your computer chassis.
qicc2.fm Page 8 Friday, April 25, 1997 12:40 PM