Service guide
March 2001
5
Symptoms
Possible causes
Remedies
The guide system
(leading to the sensor
light line) is damaged or
has a burr, which
obstructs the paper path
Find and remove
burr/damage
Roller/tire system has
too much friction or
resistance to rotate
Check bearings or
possible
interferences
Medium does not
reach paper sensor
Gate closes too tight on
Guide 2
or
The metal flag on the
right end of the gate is
bent
Straighten long leg
of the flag
Boom does not
maintain proper loop
shape of the sheet
during the first side
printing
and
Motor 3 runs
Suspension spring(s) is
damaged thus producing
friction in boom guides
Replace spring(s)
Boom suspension
springs curls during
first side printing
One way clutch defective Replace pulley/clutch
assembly of spring
drum shaft
One way clutch defective Replace pulley/clutch
assembly of feed
shaft
Sheet dropped by
SpinJet before being
fed into printer
Coil spring holding
central roller shaft
disengaged/lost
Reinstall/replace
Paper does not feed
into printer
and
Motor does not try
to feed
and
No error signal
Distance between right
and left encoder sensor
too long
Loosen, hold
together and fasten
Harness #4 defective
Replace
Paper does not feed
into printer
and
Motor does not try
to feed
and
Error code 06
displayed
Motor 1 defective
Replace
One way clutch defective Replace pulley/clutch
assembly of feed
shaft
Paper does not feed
into printer
and
Motor does try to
feed
and
Tires do not run
and
Error code 06
displayed
Belt defective
Replace
