Service guide
March 2001
16
5550 197 Connector PCB
Replace connector PCB by
loosening it from the 2 standoffs
and disconnect all harnesses
(picture below).
Make sure to reconnect EMC
ground strap from harness #4
and #11 with same connector
board securing screw when
reassembling.
5550 027 Assy, harness #7
connector PCB to keypad
Dismount connector PCB and
replace harness. The keypad is
part of the cover spare part
(5550 035).
5550 025 Assy, harness #5
connector PCB to motor 2 or
3
Dismount connector PCB and
disconnect harness #5. Withdraw
it through the beam and disconnect
at motor end (connectors are
located inside beam when
assembled). Reassemble in reverse
order.
5550 038 Assy, harness #4
and #11 in supporting arm.
Assembly comprises assembled
pillar, console and gas spring with
motor and signal harnesses:
§
5550 024 Assy, harness #4
main PCB to connector PCB,
motor
§
5550 029 Assy, harness #11
main PCB to connector PCB,
signal
Replacement requires removal of
the entire mechanical unit.
Disconnect harnesses at control
box and detach them from the an-
chors on the clamp.
Connector
PCB
Harness
#5 (2 pcs.)
Harness #4
and #11
strapped on
clamp.
Supporting
arm assy
Location
of screws
(4 pcs.
T20)
