RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
Page 3.12
•
RS-485 Signal
This is a digital signal exchanged between the brake board and the digital plan board. There is
no provision for monitoring its state.
•
Excitation current
This is the current generated by the brake board (pins 1-2 of connector CN2) which supplies the
brake winding. The current supplied is a function of the selected effort level and the speed of
the exercise.
•
Pulses
This is the signal produced by the speed sensor, and has the waveform shown below:
Figure 3.2-1
The signal enters the brake board (pins 3-4 on connector CN2), where it is used to determine the
speed value that is sent to the digital plan board via the RS-485 serial link.
This signal can also be measured qualitatively using a multimeter. With the machine
stopped the voltage measured across the sensor terminals should be 0 Vdc, and while
pedaling it should go to a few hundred mV: the higher the speed, the higher the
measured value.
Содержание RECLINE EXCITE
Страница 1: ...SERVICE MAINTENANCE MANUAL REV 1 3...
Страница 2: ......
Страница 4: ......
Страница 157: ......