Technogym RECLINE EXCITE, Руководство по техническому обслуживанию

Страница: 122 / 158

RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
Page 7.38
7.19. DISASSEMBLING THE SADDLE HANDLEBARS
Figure 7.19-1
Carry out the operations described in paragraph
7.18. “Disassembling the hand sensor board”.
1. Unplug the connector indicated in the figure,
from the board (only for the 700, 700E and
700SP models).
Figure 7.19-2
2. Back off the two screws a using a 3-mm
Allen wrench and remove the covering plate.
3. Back off the screw b using a medium Phillips
screwdriver and unplug the ground cable.
Figure 7.19-3
4. Back off the bolts c using an 8-mm Allen
wrench (two bolts for each handlebar).
5. Remove the handlebars taking care not to
damage the cables.
To reassemble the saddle handlebars, carry out
the above steps in reverse order.
During reassembly, lock down the
screws c using a torque wrench set for
70 Nm.