Technogym ISOCONTROL, Руководство по техническому обслуживанию

Страница: 57 / 72

ISOCONTROL: Service & Maintenance Manual - rev. 1.2
Pagina 7.5
Figura 7.4-3
6. Cut the cable tie c .
7. Unplug the connector c from the encoder
board.
8. Back off the 2 screws d which are securing
the encoder board.
Figura 7.4-4
To reassemble the encoder board, follow the
above steps in reverse order.
During assembly:
Check all the plastic bushing “f”
with threaded piece, are correctly
inserted inside the support “g”.
Use a cable tie where previously
esed.