Technogym ISOCONTROL, Руководство по техническому обслуживанию

Страница: 38 / 72

ISOCONTROL: Service & Maintenance Manual - rev. 1.2
Pagina 5.22
Photo 5.2-26
7. Pass the cable supplied in the kit through the
tubing, by first inserting the power supply
input connector through the hole at the top of
the frame, on the weight stack arch, and then
pulling out the connectors for the display
(Photo 5.2-27) and power supply input
(Photo 5.2-28) through the corresponding
holes in the frame.
Photo 5.2-27
8. Fit the rubber ring 3 , supplied in the kit, on
the exit hole in the frame for the cable
leading to the display.
Photo 5.2-28
9. Assemble the plug for the power input
connector B , and fit it on the hole in the
frame as shown in the figure.
Photo 5.2-29
10. Fit the rear cover of the display assembly C
on the metal bracket.
11. Pass the connector D for the display through
the bracket tubing, pulling it out by about 15
cm.
12. Fit the tubing on the frame, making sure the
cable passes through the special slot to
prevent it from being pinched, as shown in
the box of the figure.