Technogym ISOCONTROL, Руководство по техническому обслуживанию

Страница: 36 / 72

ISOCONTROL: Service & Maintenance Manual - rev. 1.2
Pagina 5.20
5.2.4. P
ROCEDURE FOR
E
LEMENT MACHINES
Photo 5.2-21
1. Using a flat-blade screwdriver, remove the
plug from the frame hole for passage of the
cable at the power inlet.
Photo 5.2-22
2. Remove the “lens plug”, indicated in the
figure to side by the arrow, backing off the
screw in the internal side of the frame using
an 7-mm hex wrench.
3. Lift up the weight stack cross and clamp it
with the pin, so as to remove tension from
the weight stack cable.
Photo 5.2-23
4. Using an 8-mm hex wrench and a 17-mm
wrench for the nut A , remove the machine
pulley that need to be replaced with that
supplied in the upgrade kit.
The pulley that need to be removed is
that placed in the central upper side of
the weight stack, next to the square hole
indicated by the arrow in the picture to
side.
5. Mount the pulley supplied in the kit taking
care to assemble it so that the knurled circle
faces the square hole and placing again the
two spacers removed previously or using the
ones in the kit.