Technogym ISOCONTROL, Руководство по техническому обслуживанию

Страница: 19 / 72

ISOCONTROL: Service & Maintenance Manual - rev. 1.2
Pagina 5.3
5.2.2. P
ROCEDURE FOR
S
ELECTION MACHINES
Photo 5.2-3
Cable passage:
1. Using an 8-mm hex wrench, remove the
machine pulley (or pulleys) that need to be
replaced with those supplied in the upgrade
kit.
To identify the pulley (or two pulleys)
that need to be removed, refer to the
pulleys indicated al paragrafo 5.2.2.2
“Pulleys to replace on Selection
machines”.
2. Using a cable push-pull rod, feed the cable
supplied in the kit in through the "power
supply" entry hole and out through the exit
holes for the encoder pulley (on the left in
the photo) and the display (on the right),
bringing the corresponding connectors
outside the frame.
There should be one connector outside
each hole for machines with one pulley
assembled, and two connectors in the
case of machines with two pulleys.
Photo 5.2-4
3. Using the special screws a , fix the plastic
support for the power connector on the
machine frame, inserting the cable holder
d
which will then secure the cable coming
from the power supply.
Photo 5.2-5
Display assembly:
4. Assemble the bracket using the two grips and
4 screws contained in the kit, and position
the cable as illustrated in the figure.
5. Assemble the back of the Isocontrol display