Technogym FORMA LINE BIKE FORMA DDC5 Series, Руководство по технической помощи

Страница: 86 / 122

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Page 7.28
7.11. DISMANTLING THE BRAKE AND THE FLYWHEEL UNIT
Figure 7.11-1
Carry out the operations in the paragraph: 7.1.
“IMPORTANT NOTE ON DISMANTLING” and
7.7. “Dismantling the guard”.
1. Disconnect the two fastons on the brake
winding, as highlighted in the figure at the
side.
2. Unscrew the 2 stop screws (a) using a 4mm
Allen wrench.
3. Remove the brake unit
(b)
with care.
DANGER: Pay particular attention to
the copper disk as it could easily
buckle.
WARNING: During re-assembly,
tighten the screws (a) using a torque
wrench set at 5Nm.
Figure 7.11-2
4. Unscrew the flywheel unit
(a)
from the
central shaft, using a 6mm Allen wrench,
while blocking it on the opposite side using a
10mm Allen wrench.
5. With care, remove the flywheel unit from the
side opposite the speed sensor.
WARNING: After re-fitting the
flywheel unit, use a comparator to
check for any buckling on the copper
disk with a margin of ± 0.15mm.
WARNING: During re-assembly,
tighten the flywheel using a torque
wrench set at 25Nm.
Continues on the next page...