Technogym FORMA LINE BIKE FORMA DDC5 Series, Руководство по технической помощи

Страница: 72 / 122

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Page 7.14
Figure 7.8-4
4. Unscrew the 4 nuts
(d)
using a 13mm
wrench, while blocking the screws on the
opposite side, using a wrench of the same
size.
WARNING:: During re-assembly,
position the screws at the top inside of
the flange before refitting the shaft
onto the frame.
WARNING: During re-assembly,
tighten the screws (d) using a torque
wrench set at 22Nm.
Figure 7.8-5
5. On the left-hand side of the equipment,
remove the snap ring (3) , the spacer (2) and
the elastic spring
(1)
.
WARNING:: During re-fitting, take
care to re-insert the components
according to the sequence shown in
the figure.
Figure 7.8-6
6. Remove the pulley shaft
(f)
from the right-
hand side, as shown in the figure.
To re-fit the pulley unit, follow the above
operations in reverse.