Technogym FORMA LINE BIKE FORMA DDC5 Series, Руководство по технической помощи

Страница: 40 / 122

Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Page 6.6
2
Chack the cable that
connect the Low Kit
with High Kit.
YES
NO
Is the voltage at the input
of the Brake Board
correct?
NO
YES
Replace
CU309 cable
NO
Replace the power
entry module
YES
Are the voltages at the
output of the Barke Board
correct?
NO
Replace the
Brake Board
4
A
3
Is the voltage at the
output of the power entry
module correct?
Follow the chart step by step in order to make a correct diagnosis. In particular, pay attention to
the checks highlighted in the numbered boxes and listed here below:
(1) Check that LEDs 1 and 2 ( green and yellow ) are lit on the Display Board.
(2) Insert the tips of the tester onto pins 3 and 1 of the CN4 connector on the Brake Board. They
should register about 220Vac or 110Vac according to the mains voltage.
(3)
Gently lift the fastons on the power supply socket on the equipment. Insert the tips of the
tester between the phase and neutral on the connector. They should register about 220Vac or
110Vac according to the mains voltage.
(4) Using the tester, measure the voltages on the CN1 connector on the Brake Board. They must
register:
• +12 Vdc between pins 6 - 2 ;
• +5 Vdc between pins 7 - 3 .
If the Display Board is replaced, check that the upgraded SW version is installed or
proceed with the upgrade.
If the Brake Board is replaced, check that the correct SW version is installed or
proceed with the upgrading of the Firmware (FW), the Brake Table and the Standard
Settings.