Technogel MIXTRONIC 110, Инструкция по установке, использованию и техническому обслуживанию

Страница: 25 / 66

25
Machine washing
DURING THE OPERATIONS FOR WASHING
AND SANITIZING THE MACHINE, WEAR THE
PROTECTION DEVICES INDICATED:
GLASSES AND RUBBER GLOVES.
(USE RUBBER GLOVES WHICH COVER THE
WHOLE FOREARM)
CLEANING INSTRUCTION
•
1) Before starting the washing operations make sure the machine is unplugged.
•
2) Open the lid and rinse the tank with hot water at a temperature of 50°:60° C and then
drain off.
•
3) Fill the tank half full with hot water 40°
÷
50°C. Add detergent e.g. ( DIVER SEY – SU891
available in Italy or DIVER SEY – VK3L available in other countries) using a concentration of
the product between 5
÷
10%.
•
4) Plug in the unit and Turn on the stirrer for a few minutes. Unplug it again.
•
5) Wash carefully using a sponge and NON-ABRASIVE materials.
•
6) Dismantle the tap, the stirrer shaft and the emulsifying cage. Clean them thoroughly
using the same solution used for washing the tank. Re-assemble the parts. (since you do
not insert how much time you clean parts will be better to insert a value)
•
7) Rinse thoroughly using copious clean water (minimum 50/70 LT)
S
S
A
A
N
N
I
I
T
T
I
I
Z
Z
I
I
N
N
G
G
•
8) Before starting production the machine must be sanitized as follows:
Prepare a solution with acid (e.g. Percitric or Peracetic) adding COLD water (MAX. 25° C)
so as to obtain a final concentration of 0,1
÷
0,3%. Keep the mixture in the machine for approx. 5
minutes making sure that all the surfaces which will come into contact with the finished product are
treated with the solution. Drain and rinse carefully using copious amounts of water. (minimum
50/70 LT)
CAUTION! DO NOT USE HOT WATER WHEN PREPARING THE ACIDS INDICATED ABOVE.
IMPORTANT: TO PREVENT ANY PROBLEMS OF CORROSION, DO NOT LEAVE THE SANITIZING
SOLUTION INSIDE THE MACHINE FOR PERIODS OF OVER 10 MINUTES.