Technogel MIXTRONIC 110, Инструкция по установке, использованию и техническому обслуживанию

Страница: 23 / 66

23
⇒
Cooling cycle
If you want to cool the mixture while the machine is heating before reaching the set heating
temperature carry out the following steps:
I° press the STOP CYCLE push button
II° press push button 85°C
III° press the CUSTOM push button once ( 04 will appear on the display)
IV° press START CYCLE push button (the machine will start to cool, will take the
mixture to +4°C and will keep it at that temperature).
⇒
Shortage of energy supply while operating
If electricity should be cut off during operation, heating will start up again at the exact point of the interruption
by means of a tampon battery in the electronic system that works the machine and will end the cycle that has
been set.
To see whether this works, simply stop the cycle by pressing the
START push button on the front part of the
machine and after a few seconds press it again. The machine will go back to the cycle at the point from
where it was interrupted.