3-7
(6)
Select AC Power, External DC Power, or Battery Operation. Refer to Paragraphs 3.5
to 3.7).
(7)
Remove the microphone from front access panel, and ensure that the microphone
connector is connected to the MIC/PTT connector of the transceiver.
(8)
Set the SQUELCH control in the fully counter-clockwise (CCW) position.
(9)
Set the VOLUME control in the 12 o'clock centre position.
(10)
Set the POWER ON/OFF switch to "ON".
(11)
Verify that the FUSE BLOWN red LED is OFF.
(12)
Verify that the POWER ON green LED is ON.
(13)
Set up Keypad "Beeps" as desired.
Refer to Keypad "Beeps" paragraph 3.4.1.
(14)
Set up Keypad and LCD Display Lighting as desired.
Refer to Keypad and LCD Display Lighting, paragraph 3.4.2.
(15)
Set up Transmitter Time-Out-Timer as desired.
Refer to Transmitter Time-Out-Timer, paragraph 3.4.3.
(16)
Select Frequency/Channel or operating mode as desired.
Refer to Front Panel Keypad Operation, paragraph 3.4.
(17)
Proceed to operate in the transmit mode, paragraph 3.3.2, or operate in the receive
mode, paragraph 3.3.3, as required.
3.3.2 Transmitter Operation
To operate the transceiver in the transmit mode, proceed as follows:
(1)
Set 7W/15W RF POWER switch to desired operating level.
NOTE
RF Power setting and duty cycle (ratio of Tx to Rx
operation) seriously affects Battery Operating time.
Fully charged batteries will perform for:
-12 Hours minimum in Receive mode only.
-5 Hours minimum (50% duty cycle) @ 7 Watt
-2 Hours minimum (50% Duty Cycle) @ 15 Watt
Содержание TiL-91-DE/S
