40
1.
Touch the ‘Settings’ icon to enter the setup screen
2.
Touch the ‘Counter Reset’ icon to reset the counter
3.
Touch the ‘Accept’ icon to confirm
or touch the
‘Cancel’icon
to exit without resetting counter.
9.5.8
To Run in Dot or Line Mode
1.
Touch to toggle between the line
or dot
icons
to switch mode.
Note
: switching from Line to Dot mode may
required a re-entry of a specific number of pulses desired to run
the parameter or setup.
1.
2.
Touch ‘Run’ icon to start the dispensing cycle
3.
If Line Mode is selected an external triggering devise is required
to trigger a start.
Caution:
Line mode, the controller must be activated by secondary
source such as PLC or XYZ Table connected through 15-Pin I/O port.
