10
8 SAFETY
INSTRUCTIONS
The series CIP II of programmable totalizers are in conformity with all
essential requirements of all EC directives applicable to them:
2014/30/EU Electromagnetic
compatibility directive (EMC)
2012/19/EU
Waste electric and electronic equipment directive
(WEEE).
2011/65/EU
Directive relating restriction of the use of certain
hazardous substances in electrical and electronic
equipment (ROHS).
Equipment for hazardous areas:
2014/34/EU Directive
relating
equipment and protective systems
intended for use in potentially explosive
atmospheres (ATEX).
Declarations of conformity EC can be downloaded from the section “Downloads” of the
Tecfluid S.A. website. www.tecfluid.com
8.1
Certificate of conformity TR CU (EAC marking)
Tecfluid S.A. have subjected the series CIP II of programmable
totalizers to a certification procedure according to the technical
regulations of the Customs Union of the Eurasian Economic Union
(EEU).
This Certificate is an official document confirming the quality of production with the
standards on the territory of the Customs Union, particularly regarding safety requirements
and electromagnetic compatibility.
9
ADDITIONAL INSTRUCTIONS FOR THE ATEX VERSION
This chapter only applies to equipment intended for use in explosive atmospheres.
9.1 Flameproof
enclosure
These equipment conform with the directive 2014/34/EU (Equipment and protective systems
intended for use in potentially explosive atmospheres) as indicated in the EC-type
examination certificate LOM 14ATEX2006 X, LOM 14ATEX2008 X and its marking.
Given that this instrument belong to group II, it is intended for use in places likely to become
endangered by explosive atmospheres, but not in mines.
The category is 2GD, that is, it is intended for use in areas in which explosive atmospheres
caused by mixtures of air and gases, vapours, mists or air/dust mixtures are likely to occur.
9.1.1 Surface
temperature
Equipment is certificated as Exd IIC T6.
The maximum possible surface temperature is 85ºC.
WARNING: RISK OF IMPACT
Because the housing is made of aluminium, the equipment must be installed and
operated always in locations at low risk of impact.
