Tecfluid CIP II, Инструкция по эксплуатации

Страница: 4 / 14

4
1 INTRODUCTION
The CIP II converter is designed to work with oscillating piston flowmeters (COVOL) and
turbine flowmeters series TM.
The circuit is based on a microprocessor that, in function of the programmed pulses per unit
of volume, totalizes the volume that flows through the meter and shows this value on the
display. The CIP II has two volume totalizers, one that can be reset (partial) and the other
that cannot be reset (total).
This instrument is battery powered and does not require any wiring. This makes its
installation very easy.
2 MODELS
3 ELECTRICAL CONNECTION
No electrical connections are required for the local indication models. Just screw the
connector at the back of the converter onto the connector base of the flowmeter, previously
checking that the sealing gland is correctly situated in the bottom of the connector base. The
converters are supplied already configured for the type of flowmeter to be used (COVOL or
TM).
Connections are the following:
Terminal COVOL Turbine
1 Reed Ground
2 Reed Live coil
3 - - - Live coil
For the remote wall mounting models, the connections should be made as follows:
COVOL oscillating piston flowmeter
Flowmeter terminal N. Connection CIP II terminal N.
1 Reed 1
2 Reed 2
TM turbine flowmeter
Flowmeter terminal N. Connection CIP II terminal N.
1 Shield 1
2 Live Coil 2
3 Live Coil 3
The earth terminal of the CIP II connector should not be connected.
CIP II - -
C COVOL input
T TM input
L Local mounting on the flowmeter (IP65)
M Remote wall mounting (IP65)