TE Connectivity CBP-5T Mk II, Руководство пользователя

Страница: 13 / 92

409-35001
Rev C
13 of 92
4. Reattach monitor articulating arm (2216845-1) to the preferred side of the machine. Attach monitor to
arm with supplied mounting screws (3-18023-7). Reattach monitor power cord and video cable.
5. Reinstall Barcode Reader (if supplied).
6. Remove Press Head lockdown brackets (one on left side and one on right side).
7. Attach keyboard to UI computer in control cabinet.
8. Attach mouse, keyboard, touchscreen and external USB cables to UI computer in control cabinet.
9. Power up Press by turning on Master Power Switch. The system will boot to the home screen. The
default username Administrator has a default password of administrator .
NOTE
Administrator (Customer / Owner) should change the initial login password to secure the machine from unauthorized access.
Facilities Labeling
The machine part number, serial number, manufacture date, and electrical specification are given on the
label on the left side of the machine as shown in Figure 12.
Figure 12
Electric Supply Circuit
Refer to the Facilities Labeling on the left side of the machine for exact requirements but in general, the
electrical supply circuit must match the following: 200 to 240 VAC, 50/60Hz, 1 phase, 2 wire service. It
must be protected by a breaker rated for at least 10,000 IAC.
Pneumatic Supply
The pneumatic supply must be connected to the port provided at the lower left corner of the press.
Pressure between 552-827 kPa [80-120 psi] is acceptable. Compressed air is used only for the head
positioning air bearing and optional Air Table. Air consumption is minimal.
4. MACHINE END OF LIFE CYCLE
A decommissioned machine should be returned to TE Connectivity for proper disposal.
5. PRESS OVERVIEW
This section introduces the CBP, CSP, and CMP presses. They will be collectively referred to in this manual as
C
x P. A brief review of the purpose, capabilities, options, and layout is given.