TDT C-Series, Руководство пользователя

Страница: 100 / 136

C-M-G Series
Manual
© TDT GmbH Chapter 7: The Permanent Save Menu Seite 100 von 136
7 The Permanent Save Menu
7.1 Save Config
The C-, M- and G-Series operating system is only running in the main memory (RAM). Adjustments
carried out in any of the configuration modules and activated with Save or Apply, only takes effect at
runtime.
In order to finish a configuration procedure, it is necessary to save all changes permanently.
Therefore navigate to
Permanent Save
and press
Save Config
.
Important!

Run
Permanent Save > Save Config
to store your current configuration
including all changes and adjustments permanently on the router
otherwise these changes will be lost after next reboot or power cycle.
CLI Equivalent:
Use
write
in CLIs main menu to run a Permanent Save.
7.2 Save System to USB (only M- und G-Series)
The M- and G-Series units provide the ability to backup the hole operating system to a USB stick.
Therefore it is necessary to use a TDT USB Init-Stick.
Connect the USB Init-Stick supplied by TDT to a
USB
interface.
Start backup procedure using
Permanent Save > Save System to USB
, optionally it is
possible to start the backup from a command line interface using
save_system_to_usb
.
The process may take several minutes.
Important:
Don't remove the stick until you get the
System backup finished
message.
To restore a USB system backup, proceed as described in chapter
9.2 (Restoration of the delivery status
> M3000 / G5000 ).
Important!

Only the currently running system will be saved to the USB stick.

During the restoration process from a USB stick, the backup will be restored on both
systems .