C-M-G
Series
Manual
© TDT GmbH
Chapter 9: Restoration of the delivery status
Seite 104 von 136
9 Restoration of the delivery status
In case the router reaches a condition where no further connection is possible, then a reset to the delivery
status is necessary.
Follow the procedure for your kind of device.
Note
Configurations generated with the »Configuration Handling« will remain available after a
factory reset.
9.1 C-Series
Using a pointed object (e.g. a paper clip) press and hold the reset button for at least 15 seconds
During the 15 seconds the LEDs L1 to L3 begin to illuminate one after another
After factory settings have been restored successfully the router will reboot automatically.
On C-Series routers the reset button has several other functions beside factory reset.
When the reset button is pressed the LEDs L1 to L3 illuminate one after another, according to the
combination of the LEDs the release of the reset button has different functions:
Active LED
Time
Function
Power
0 - 3 seconds
Reboot of the C1500
Power, L1
4 - 14 seconds
The C1500 switches off
Power, L1, L2
≥ 15 seconds
Reboot of the C1500 and loading of the standard
configuration (Factory Reset)
9.2 M3000 / G5000 / L-Series
Perform a regular system shut down if possible. Using the webinterfaces menu
System >
Bootup and Shutdown
by pressing the
[Shutdown System]
button or via command line
using the command
halt
.
Connect the USB Init-Stick supplied by TDT to one of the
USB
interfaces and start the unit again.
During the boot sequence the unit recognises the USB Init-Stick and automatically reinstalls the
original factory system or the backuped system (see chapter
The process may take several minutes.
The end of the recovery process is shown by 10 acoustic signals and the unit shuts down.
After restoration is finished, remove the USB Init-Stick and start the unit.
Note
During the restoration process from a USB stick
both systems
will be overwritten.
