Cable select* IDE* configuration:
For best results when using cable select* mode, the TDK
DVD-R/RW writer should be connected to the cable select* IDE* cable in the master* position.
Changing jumper settings:
To remove a jumper, gently pull it off with your fingers or a pair of
needle-nose pliers. To install a jumper, gently push it onto the jumper pins (see Fig. 7).
Figure 7:
Installing jumpers across vertical pairs of pins
CAUTION:
Ensure power to the writer is OFF before repositioning jumpers.
CAUTION:
The jumper must be positioned across a set of pins as shown
(vertically). Never connect a horizontal pair of pins (i.e. crosswise) as this could
damage the writer.
ALWAYS
install jumpers
vertically.
NEVER
install
jumpers horizontally.
Jumper
23
