DUCKING AMOUNT
This sets how much attenuation (gain reduction) is
applied to the reverb signal when a vocal is present. For
ducking to not be too obvious, a slight reduction of -6
is best.The DUCKING parameter must be set to ON for
this to have any effect.
DUCKING TIME
Ducking time sets how long it takes to ramp up the
reverb level at the end of vocal phrases.
LEAD to REV
Sets the amount of lead level sent into the Reverb block.
HARM to REV
Sets the amount of harmony level sent into the Reverb
block. Harmonies must be on to feed this send.
DEL to REV
This allows you to feed the reverb block with the
effected output of the delay block. The DELAY
footswitch must be on to feed this send.
LEAD MUTE
When set to ON, your lead voice will be muted when
the Reverb effect is turned on.This allows for 100% wet
reverb effects.Any active effect that has LEAD MUTE set
to ON will mute the lead voice in the entire effect chain,
even if the other effects have it set to OFF.
Note that the LEAD EFFECT SENDS parameter on the
PRESET tab must be set to PRE in order for any signal
to get to the Reverb block when LEAD MUTE is set to
ON.
The Edit Menu: REVERB Tab
64
Содержание VoiceLive 2
Страница 1: ...USER S MANUAL...
Страница 9: ...9 Front Panel 1 2 4 5 6 7 8 9 3 11 10 12 13 14 15 16 17 18...