TBB Energier Pro CF2060L, Руководство пользователя

Страница: 46 / 60

Energier pro User Manual
39
Check the DC input voltage of this Energier pro Inverter Charger Combination is same to your battery nominal voltage. NEVER try to
connect different DC input to Energier pro Inverter Charger Combination.
Inspect the right polarity of DC on service battery, otherwise unit can not power ON.
Please check if you connect the Negative terminal of starter battery to the DC– terminal of Energier pro Inverter Charger Combination.
Inspect AC input and AC output is correct, make sure unit is no short cut.
AEA function is not available when Energier Pro is set as Solar mode.
With the switch the unit can be switched to “ON” or “CHG ONLY”. When the unit is switched “ON”, Energier pro Inverter Charger
Combination will start charging in case AC input is present. When the AC input is not present, Energier pro Inverter Charger
Combination will go to inverter mode automatically.
In case the user does not want to use the inverter mode, but wants the batteries to be fully charged, the “CHG ONLY” can be
selected. In this way the batteries will be fully charged, but if the AC input is not present, the batteries will not be drained by the
inverter mode.
7.1 Double Checking
Check the AC input limit of your system (either diesel generator or grid).
On RCF connected, you can set the input. Total nine rating are available (4 A , 6 A , 10 A , 12 A , 16 A , 20 A , 25 A , 30 A ,unlimited).
By pressing the button( )until beep was heard and the rating LEDs are flashing, you can enter into setting.
Pressing “Input Current Setting” button again to choose the rating you would like to set.
After make the choice, press “Input Current Setting” button for about 5 seconds until beep was heard to save the change.
7.2 Set the AC input current
7.3 Main switch function
7.Operation
: illuminate : extinguish : flash