Weekly Cleaning
(continued)
©McDonald’s Corporation · Australia · Planned Maintenance Manual · Revised November, 2013
Page 3 of 7
Ta
ylor Company Blended Ice Machine Model C029 -
Australia
Weekly
BE 22 W1
14
Additional pitcher cleaning.
To remove film build-up on
the inside of the blender
pitchers, place the pitchers in
the 3-compartment sink. Pour
½ scoop of
KAY Destainer
into one pitcher. Fill the
pitcher with warm water and
allow it to soak for 5 – 10
minutes. Wearing PPE
gloves, brush clean to remove
residual soil.
Note: Use caution when
cleaning the blender blade.
Destainer
Transfer the solution into the
second pitcher and repeat the
procedure. Once this is
completed, discard the
solution. Rinse and sanitize
the pitchers in the 3-
compartment sink. Allow the
pitchers to air dry.
15
Clean ice shaver assembly.
Using the squeeze bottle of
APC solution, flush the ice
shaver assembly, while
brushing with the large, white
ice hopper brush.
APC solution
16
Clean, rinse, and sanitize ice
shaver assembly.
Using the squeeze bottle of
APC
solution, flush inside,
outside, and under the ice
shaver assembly, thoroughly
covering all surfaces.
Flush the solution under the
lip of the plastic cover. Make
sure solution is applied in a
complete 360° circle.
Repeat Steps 15 and 16, using
clean, warm water.
Repeat Steps 15 and 16, using
sanitizing solution.
APC & Sanitizer solutions
17
Place buckets in front of
machine.
Place the three buckets on the
floor in front of the machine.
The bucket containing the
APC
cleaning solution will be
used first.
18
Install cleaning tubes.
Install cleaning tubes onto all
inlet fittings.
Place the other end of the
cleaning tubes into the bucket
of
APC
solution.
APC solution
19
Re-install rinse station
assembly and install cleaning
hose.
Slide the cleaning hose
adaptor onto the dispensing
head. Wedge the other end of
the hose into the rinse station
grate.
20
Open all CO2 valves.
Turn all CO2 valves to the
“
down/on
” position to open
all the pumps.
