Weekly Cleaning
(continued)
©McDonald’s Corporation · Australia · Planned Maintenance Manual · Revised November, 2013
Page 5 of 7
Ta
ylor Company Blended Ice Machine Model C029 -
Australia
Weekly
BE 22 W1
29
Clean, rinse, and sanitize
dispensing head and
surrounding area.
Using the spray bottle of
APC
and the spout brush,
clean the dispensing head
area.
Repeatedly dip the mix tube
brush into the bucket of
APC
solution and brush clean the
dispenser head openings.
Repeat this step, using clean,
warm, water and then with
sanitizing solution.
Note:
This step must be
performed every 4 hours.
APC & Sanitizing solutions
30
Re-install ice hopper and ice
hopper cover.
31
Install cabinet drip pan and
product bin shelves.
32
Install the product.
Install the product bags into
the product bins, with the
spout facing down. Position
the rear groove of the spout
into the front slot of the
product bin. Make sure it’s
properly snapped into place.
Install the product bins.
33
Install ice chute and splash
guard.
34
Install a blender pitcher.
Place a blender pitcher in the
dispensing area.
35
Press the NEXT key to prime
the product lines.
After the last product line has
been primed, press the NEXT
key.
Remove the blender pitcher
and discard the product into
the back sink.
Do not pour
down the rinser.
IMPORTANT! Do not
calibrate for at least two
hours after performing the
weekly cleaning. Product
must be 1-4 °C to calibrate.
36
Clean and sanitize dispensing
drain area.
Using the squeeze bottle of
APC, thoroughly flush the
dispensing area.
Repeat this step, using
sanitizing solution.
APC & Sanitizing solutions
