Section 6
6-1
Models 702/741/772
Operating Procedures
6
Operating Procedures
The Model 702 has been selected to show you the
pictured step-by-step operating procedures for all models
contained in this manual. These models, for practical
purposes of operation, are the same.
Each model stores 20 quarts (18.9 liters) of mix in the
hopper. The mix then flows
by gravity
through a mix
feed tube down into the freezing cylinder.
Locate your model number below to determine the
characteristics of your freezer.
702: One 4 qt. (3.8 L) freezing cylinder.
741: One 7 qt. (6.6 L) freezing cylinder.
772: Two 7 qt. (6.6 L) freezing cylinders.
We begin our instructions at the point where we enter the
store in the morning and find the parts disassembled and
laid out to air dry from the previous night’s cleaning.
The following procedures will show you how to assemble
the parts into the freezer, sanitize them, and prime the
freezer with
fresh
mix in preparation to serve your first
portion.
If you are disassembling the machine for the first time or
need information to get to this starting point in our
instructions, turn to “Disassembly” on page
there.
Assembly
WARNING!
Make sure the control switch is in
the OFF position to eliminate the chance of moving parts.
Failure to follow this instruction may result in severe
personal injury from hazardous moving parts.
Note:
When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube).
1. Lubricate the groove and shaft portion that comes in
contact with the bearing on the beater drive shaft.
Slide the seal over the shaft and groove until it fits
into place.
Do not
lubricate the hex end of the drive
shaft. Fill the inside portion of the seal with 1/4 in.
more lubricant and evenly lubricate the flat side of the
seal that comes in contact with the bearing.
Figure
6-1
2. Insert the drive shaft through the rear shell bearing in
the freezing cylinder and engage the hex end firmly
into the gear box coupling.
Figure
6-2
WARNING!
Use extreme caution
when
handling the beater assembly.
The scraper blades are
sharp and may cause injury.
3. Before installing the beater assembly, check the
scraper blades for any signs of wear or damage. If a
scraper blade is nicked or worn, replace both blades.
11078
10229
Содержание 741
Страница 10: ...1 6 TO THE INSTALLER Models 702 741 772 To the Installer 1...
Страница 32: ...6 8 OPERATING PROCEDURES Models 702 741 772 Operating Procedures 6 Notes...
Страница 38: ...9 2 PARTS REPLACEMENT SCHEDULE Models 702 741 772 Parts Replacement Schedule 9 Notes...
Страница 44: ...11 4 LIMITED WARRANTY ON PARTS Models 702 741 772 Limited Warranty on Parts 11 Notes...