![background image](http://html1.mh-extra.com/html/taylor/741/741_operators-manual_3771681031.webp)
OPERATING PROCEDURES
6-7
Models 702/741/772
Operating Procedures
6
Disassembly
Note:
Failure to remove, brush clean, and air dry parts
will result in damage to the parts.
WARNING!
Make sure the control switch is in
the OFF position to eliminate the chance of moving parts.
Failure to follow this instruction may result in severe
personal injury from hazardous moving parts.
1. Remove the handscrews, freezer door, gasket, front
bearing, beater, scraper blade(s), and drive shaft
from the freezing cylinder. Take these parts to the
sink for cleaning.
2. Remove the rear drip pan from the front panel.
Note: If the drip pan is filled with an excessive
amount of mix, the drive shaft seal should be
replaced or was improperly lubricated.
Repeat steps 1 and 2
for the second freezing cylinder on
Model 772.
3. Remove the front drip tray and the splash shield.
Brush Cleaning
1. Prepare a sink with a cleaning solution (examples:
Kay-5
®
or Stera-Sheen
®
).
Important! Use warm water and follow the
manufacturer's specifications.
Important! If an approved cleaner other than Kay-5
®
or Stera-Sheen
®
is used, dilute it according to the
label instructions.
Important! Follow the label directions. Too strong of
a solution can cause parts damage. Too mild of a
solution will not provide adequate cleaning.
Make sure all brushes provided with the freezer are
available for brush cleaning.
2. Remove the seal(s) from the drive shaft(s).
3. Remove these items from the freezer door(s).
•
Gasket(s)
•
Front bearing(s)
•
Design cap(s)
•
Draw valve(s)
4. Remove all O-rings.
Note: To remove O-rings, use a single-service towel
to grasp the O-ring. Apply pressure in an upward
direction until the O-ring pops out of its groove. With
the other hand, push the top of the O-ring forward. It
will roll out of the groove and can be easily removed.
If there is more than one O-ring to be removed,
always remove the rear O-ring first. This will allow the
O-ring to slide over the forward rings without falling
into the open grooves.
5. Thoroughly brush clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix
film is removed. Take particular care to brush clean
the draw valve core in the freezer door(s). Place all
the cleaned parts on a clean, dry surface to air dry
overnight.
6. Return to the freezer with a small amount of cleaning
solution. With the black bristle brush, brush clean the
rear shell bearing(s) at the back of the freezing
cylinder(s).
Figure
6-21
7. Wipe clean all exterior surfaces of the freezer.
10233
Содержание 741
Страница 10: ...1 6 TO THE INSTALLER Models 702 741 772 To the Installer 1...
Страница 32: ...6 8 OPERATING PROCEDURES Models 702 741 772 Operating Procedures 6 Notes...
Страница 38: ...9 2 PARTS REPLACEMENT SCHEDULE Models 702 741 772 Parts Replacement Schedule 9 Notes...
Страница 44: ...11 4 LIMITED WARRANTY ON PARTS Models 702 741 772 Limited Warranty on Parts 11 Notes...