3-2
SAFETY
Models 441 & 444
Safety
3
•
If the supply cord is damaged, it must be
replaced by an authorized Taylor service
technician in order to avoid a hazard.
Failure to follow these instructions may result in
electrocution. Contact your local authorized Taylor
distributor for service.
WARNING! DO NOT
use a water jet to clean or
rinse the unit. Failure to follow these instructions may
result in serious electrical shock.
WARNING!
Avoid injury.
•
DO NOT
allow untrained personnel to operate
this unit.
•
DO NOT
operate the unit unless all service
panels and access doors are restrained with
screws.
•
DO NOT
remove any internal operating parts
(including, but not limited to, freezer door,
beater, or scraper blades), unless all control
switches are in the OFF position.
Failure to follow these instructions may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
WARNING!
This unit has many sharp edges
that can cause severe injuries.
•
DO NOT
put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
•
USE EXTREME CAUTION
when removing the
beater assembly. The scraper blades are very
sharp.
CAUTION!
This machine must be placed on a
level surface. Extreme care should be taken when
moving for any reason. Two or more persons are
required to safely move this machine. Failure to comply
may result in personal injury or damage to the machine.
NOTICE!
Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please refer
to the cleaning section of this manual for the proper
procedure to clean this unit.
CAUTION!
This unit is equipped with a
refrigerated cabinet, designed to maintain product
temperature at or below 41°F (5°C). Before replenishing
the mix supply, the product must be refrigerated at or
below 41°F (5°C). Failure to follow this instruction may
result in health hazards and poor freezer performance.
DO NOT
run the unit without product. Failure to follow
this instruction can result in damage to the unit.
DO NOT
obstruct air intake and discharge openings. A
minimum of 3 in. (76 mm) air clearance on both sides of
the unit is required. It is recommended to place the rear
of the unit against the wall to prevent the recirculation of
warm air. Failure to follow this instruction may cause poor
freezer performance and damage to the machine.
For Indoor Use Only:
This machine is designed to
operate indoors, under normal ambient temperatures of
70°F to 75°F (21°C to 24°C). The machine has
successfully performed in high ambient temperatures of
up to 104°F (40°C) at reduced capacities.
Noise Level:
Airborne noise emission does not exceed
78 dB(A) when measured at a distance of 39 in. (1.0 m)
from the surface of the machine and at a height of 62 in.
(1.6 m) from the floor.
!
!
