OPERATING PROCEDURES
6-3
Models 441 & 444
Operating Procedures
6
8. Lubricate the inside of the freezer door spout, top
and bottom. Insert the draw valve into the freezer
door from the top. It will be necessary to rotate the
draw valve to the right
when assembling the door to
the freezer.
Figure 6-7
9. Place the freezer door gasket into the groove on the
back of the freezer door. Slide the front bearing over
the baffle rod so the flanged edge is against the door.
Do not
lubricate the gasket or bearing.
Figure 6-8
10. Insert the baffle rod through the beater in the freezing
cylinder. With the door seated on the freezer studs,
install the handscrews. Tighten equally in a
crisscross pattern to ensure that the door is snug.
Figure 6-9
11. Rotate the draw valve bracket to the left. Center it
into position by raising the draw arm and placing it
into the slotted groove of the draw valve bracket.
Figure 6-10
12. Lay the mix feed tube in the bottom of the mix
hopper.
13. Repeat steps 1 through 12 for the other side of the
freezer on the Model 444.
11101
11104
10236
10237
