Section 3
3-1
Models 441 & 444
Safety
3
Safety
We, at Taylor Company, are concerned about the safety
of the operator at all times when they are coming in
contact with the unit and its parts. Taylor makes every
effort to design and manufacture built-in safety features
to protect both operators and service technicians.
Installing and servicing refrigeration equipment can be
hazardous due to system pressure and electrical
components. Only trained and qualified service
personnel should install, repair, or service refrigeration
equipment. When working on refrigeration equipment,
observe precautions noted in the literature, tags, and
labels attached to the unit and other safety precautions
that may apply. Follow all safety code requirements.
Wear safety glasses and work gloves.
DANGER!
Failure to adhere to the following
safety precautions may result in severe personal injury or
death. Failure to comply with these warnings may also
damage the unit and/or its components. Such damage
may result in component replacement and service repair
expenses
.
NOTICE! DO NOT
operate this machine
without reading this entire manual first. Failure to follow
all of these operating instructions may result in damage
to the machine, poor performance, health hazards, or
personal injury.
IMPORTANT! This appliance is to be used
only by trained personnel. It is not intended for use by
children or people with reduced physical, sensory, or
mental capabilities or lack of experience and knowledge.
Where limited equipment operation is allowed for public
use, such as a self-serve application, supervision or
instruction concerning the use of the appliance by a
person responsible for their safety is required. Children
should be supervised to ensure that they do not play with
the appliance.
IMPORTANT! An equipotential grounding lug is
provided with this unit. Some countries require the
grounding lug to be properly attached to the rear of the
frame by the authorized installer. The installation location
is marked by the equipotential bonding symbol (5021 of
IEC 60417-1) on both the removable panel and the unit's
frame.
WARNING!
Avoid injury.
•
DO NOT
operate the unit unless it is properly
grounded.
•
DO NOT
operate the unit with larger fuses than
specified on the unit's data label.
•
All repairs should be performed by an
authorized Taylor service technician.
•
The main power supplies to the unit must be
disconnected prior to performing installation,
repairs, or maintenance.
•
Units that are permanently connected to fixed
wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have protective devices to
protect against the leakage of current, such as a
GFI, installed by the authorized personnel to the
local codes.
•
Stationary units which are not equipped with a
power cord and a plug or another device to
disconnect the appliance from the power source
must have an all-pole disconnecting device with
a contact gap of at least 0.125 in. (3 mm)
installed in the external installation.
•
Supply cords used with this unit shall be
oil-resistant, sheathed flexible cable not lighter
than ordinary polychloroprene or other
equivalent synthetic elastomer-sheathed cord
(code designation 60245 IEC 57) installed with
the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors from
abrasion.
!
!
