Section 1
1-1
Models 441 & 444
To the Installer
1
To the Installer
The following information has been included in the
manual as safety and regulatory guidelines. For complete
installation instructions, please see the Installation
Checklist.
Installer Safety
IMPORTANT! In all areas of the world,
equipment should be installed in accordance with
existing local codes. Please contact your local authorities
if you have any questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and service
of Taylor
®
equipment.
•
Only authorized Taylor service personnel should
perform installation, maintenance, and repairs
on Taylor equipment.
•
Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the industry
standards on lockout/tagout procedures before
beginning any installation or repairs.
•
Authorized service personnel must ensure that
the proper protective equipment (PPE) is
available and worn when required during
installation and service.
•
Authorized service personnel must remove all
metal jewelry, rings, and watches before work-
ing on electrical equipment.
DANGER!
The main power supply(s) to the
unit must be disconnected prior to performing any
installation, maintenance, or repairs. Failure to follow this
instruction may result in personal injury or death from
electrical shock or hazardous moving parts as well as
poor performance or damage to the unit.
Note:
All repairs must be performed by an authorized
Taylor service technician.
WARNING!
This unit has many sharp edges
that can cause severe injuries.
Site Preparation
Review the area where the unit will be installed before
uncrating the unit. Make sure all possible hazards to the
user or equipment have been addressed.
For Indoor Use Only:
This unit is designed to operate
indoors, under normal ambient temperatures of 70°F to
75°F (21°C to 24°C). The freezer has successfully
performed in high ambient temperatures of 104°F (40°C)
at reduced capacities.
WARNING!
This unit must
NOT
be installed in
an area where a water jet or hose can be used.
NEVER
use a water jet or hose to rinse or clean the unit. Failure
to follow this instruction may result in electrocution.
CAUTION!
This unit must be installed on a
level surface to avoid the hazard of tipping. Extreme care
should be taken in moving this unit for any reason. Two
or more persons are required to safely move this unit.
Failure to comply may result in personal injury or damage
to the unit.
The authorized installer should inspect the unit for
damage and promptly report any damage to the local
authorized Taylor distributor.
This unit is made using USA sizes of hardware. All metric
conversions are approximate and vary in size.
!
